The industrial sliding door is composed of a series of door panels that rise along the track. The torsion spring system or counterweight system is used to ensure the balance of the door body. The installation track is as close to the inside of the building as possible, which can greatly save the interior space of the building. The size and shape of the building, its lifting doors can be designed in different ways. The selection of the door lifting method can be based on the following basic conditions: the size of the door opening; the upper space of the door opening; the side space of the door opening; and the door opening depth. According to the actual situation of the building site, combined with the owner's requirements for the use of space, the following lifting methods can be implemented to meet the requirements for reasonable use of space to a greater extent.

Features:

1. Appearance: Double-layer galvanized steel plate with polyurethane layer, the surface embossing design can make the door panel durable, easy to clean, beautiful and generous, and enhance the corporate image.

2. Applicability: According to the design of the building structure, the lift door opens vertically upwards and hangs on the inside of the wall above the door opening without occupying any space in the room; it takes full advantage of the vertical rise without occupying both sides of the door opening to release the door opening space to a greater extent.

3. Wind resistance: When the door body reaches a certain width, external stiffeners are designed to ensure its strength. Tested by European standards, it can withstand instantaneous level 10 wind.

4. Noise isolation: low noise opening, galvanized pulley seat is equipped with adjustable ball bearings and wear-resistant rubber wheels, to ensure that the door opens and closes quietly.

5. Door panel material: The door panel is made of thick double-layer galvanized steel sheet, and the interior is made of high-density polyurethane foam material. It has the advantages of heat insulation, sound insulation, heat preservation, etc., and is used in large warehouses and factory doors; industrial lift doors Door panels can be made up to 10 meters wide.

6. Safety device: anti-fall device, airbag (optional), to prevent the door from falling or the bottom of the door colliding with obstacles, the door will automatically stop or run in reverse to prevent accidents; wire rope break device, torsion spring Break safety device. Prevent the door body from harming people and things in any way.

7. Air tightness: The top, bottom and both sides of the door panel are equipped with high-quality rubber sealing strips. There are also reliable seals between the door panels to ensure that the door body will not be corroded with sealing strips around it.